15
ENGLISH
4.2.2 TS parameters
Service ID, Network ID (NetID), Original Network ID (ONID), Transport Stream ID (TSID), Private Data Specifier
Descriptor (PDSD) are automatically set to their correct value according to the selected country (see Tab.2).
We suggest to modify these values only if LCN does not work properly with the default configuration. For more
information about these parameters, and to retrieve the correct values, please refer to www.dvbservices.com
or check the parameters of TV broadcaster of your region.
Default values at page 28.
4.3 Warnings
• The AUTO settings of the aspect ratio works if the input signal carries the WSS (widescreen signaling).
• When connecting an AV source, if the MOD-DVB-TC is in operating mode (display OFF and TPE
disconnected), the display shows the input source format for 5 seconds (
PAL, SECAM, NTSC
,
noIn
in
case of no video input).
• In case LCN doesn’t work properly, verify the configuration on your TV/set-top box and follow instructions
on paragraph 4.2.1.
• Before connecting the TPE, wait for switching off of the display of the MOD-DVB-TC.
• Connecting a TPE, the on-board display and buttons ENT,+,- are disabled. For safety reasons, on-board
programming is restored 3 minutes after disconnecting the TPE.
• To change the type of the modulation check chapter 3.
• To restore the default settings, please check chapter 3.
