Transport platform
SEP Serie
SEP u
ser’s manual Page 23 of 89
Doc no. RD-7243-MA-001-02
Figure 7
– Regulatory attachment points
4.8. Regulatory attachment points
Important! Wear a safety harness at all times when assembling or demantling mast
sections or mast ties.
Workers exposed to fall risks must wear a safety harness certified according to local standards in
effect. The fall arrest device must be able to support a pulling force of 5 000 lbs (2 270 kg) in any
direction and can be equipped with a shock absorber. The attachment points shown on the figure
bellow respect effective standards. Please remember that improper use of the fall arrest device
can increase risks of injury. Consequently, it is recommended to have proper training in the use of
fall arrest devices before proceeding with in height work.
Important!
•
Use only the regulatory attachment points shown on
•
Only one (1) worker per individual attachment point.
•
Make a visual inspection of the proper state of an attachment point before latching a safety
harness.
•
Never use an attachment point presenting a steel defect.
•
Consider the lifting
attachments as
individual
attachment points.
IMPORTANT!
Use a harness
latched to a valid attachment
point before using the
installation tailgate platform
.
The four (4) vertical
tubes are valid as
individual attachment
points.
It is
forbidden!
to use the angled
bars as individual
attachment points.
These bars do not
have the required
minimum
resistance.
Use the harness
attachment support
as an as individual
attachment point.
Summary of Contents for SEP-5000
Page 1: ......
