112
Doc Q7.0
Chorus Unit Parameters
Each chorus unit has an identical set of parameters.
TIME
– Sets the minimum time delay of the selected chorus voice. All modulation is positive/unipolar.
LEVEL
– Sets the output level of the selected chorus voice.
PAN
– Sets the panning of the selected chorus voice in the stereo field.
DEPTH
– Sets the modulation depth for the selected chorus voice’s
MORPH
blend of
LFOs 1/2/3
.
The depth of
LFO 4
is set for all voices simultaneously via the
MAIN DEPTH
parameter on the advanced page.
LFO MORPH
– This parameter taps any one, or a blend of any two, of LFOs 1, 2, and 3 to use as a
modulation source for the current voice. The scale below shows how the percentage setting selects between
the LFOs. A value of 0% taps only LFO1, while 75% would be an even blend of LFO2 and LFO3.
Figure 5-36 – Quad Chorus LFO Morph Scale
Advanced Parameters
The “MASTER” parameters on the Advanced Page are duplicates of items on the MASTER page (detailed above).
WIDE MODE
– When this in set to “ON,” the modulation to voices 2 and 4 from their LFO MORPH outputs is
inverted to widen the stereo effect.
MAIN DEPTH
– Controls the depth of LFO4, which modulates all four chorus voices.
MAIN PHASE
– Sets the phase difference for the main LFO (LFO4) output to chorus voices 2 and 4.
LFO1 MASTER
– If this is set to “ON,” the controls for LFO 1 also control the rates.
LFO TYPE 1–4
– Selects the type of LFO for each LFO.
LFO RATE MULT 1–4
– Sets the rate of each LFO as a multiple of the
MASTER RATE
.
Note:
MASTER RATE
appears as “RATE” on the MASTER page and as “MASTER RATE” on the ADVANCED page.
Quad Chorus Mix Parameters
The
Quad Chorus
block has a
MIX
page with
MIX, LEVEL
,
BALANCE
,
BYPASS MODE,
and
GLOBAL MIX
parameters.
