Doc Q7.0
153
BYPASS
NONE/PEDAL…/0-127
Operates the front panel
button (p.
) remotely.
TEMPO TAP
NONE/PEDAL…/0-127
Provides the ability to set the Global Tempo (see p.
) through a remote switch.
IMPORTANT:
Any data value (0-127) for the assigned CC# counts as a tap, so do not
use a momentary switch set up to send 127 for ON and 0 for OFF, or you will end up
with double-time!
TUNER
NONE/PEDAL…/0-127
Provides a way to enter or exit the TUNER function remotely.
EXT CTRL 1–12
NONE/PEDAL…/0-127
This is where you specify which incoming MIDI CC# should be assigned to each of the
12 External Controllers available as Modifier sources (p.
LOOPER REC, PLAY,
ONCE, DUB, REV,
BYPASS, HALF, UNDO,
METRONOME
Each of the controls of the Looper block (p.
) may be remote controlled.
SCENE SELECT,
SCENE INCR,
SCENE DECR
These options allow selecting SCENES (p.184) via MIDI CC#.
For SCENE SELECT, the value of the Control Change message determines which scene
is loaded. The easy rule is CC# Value + 1 = Scene number. (Ex: Value 0 = Scene 1).
However, values greater than 7 continue to select scenes, in order. To determine the
scene for values >7, divide by 8. The REMAINDER is the scene that will be selected.
SCENE INCR and SCENE DECR are triggered only by CC# data values greater than 63.
VOLUME INCR,
VOLUME DECR
NONE/PEDAL…/0-127
These two options provide a convenient way to
permanently
increase or decrease
the MAIN volume (OUTPUT 1) of the currently loaded preset. Each time VOL INCR is
triggered by a CC# value greater than 63, the MAIN is increased by 1.0 dB and the
preset is saved. VOLUME DECR, works the same way, decreasing volume.
NOTE: The MAIN fader is located on the OUT page of the Layout menu.
IMPORTANT!
Any other unsaved changes such as altered effect parameters or bypass
states will also be stored if either
VOLUME INCR
or
VOLUME DECR
is triggered.
WARNING!
These functions are designed for use with
momentary
footswitches
set up
to send a CC# value of 127 for “ON” and 0
for “OFF”. Do not use an expression pedal
or you may change /-20 dB with a single sweep!
AMP1 BYP
AMP 2 BYP
CAB 1 BYP
… THROUGH…
WAH 2 BYP
Every block instance in the inventory of the Axe-Fx II except FB SEND, FB RETURN,
and SHUNT can be set up with a global, dedicated MIDI CC assignment to control its
bypass state. The complete list of default effect bypass assignments can be found in
the
Factory Defaults
section of the Appendix.
AMP1 XY
AMP 2 XY
CHO1 XY
… THROUGH
WAH 2 XY
The X/Y switching feature equips various Axe-Fx II blocks with dual independent sets
of parameters, making it possible to have two completely different switchable
settings for a single block. Data values from 0–63 will select the Y state, while values
from 64–127 will select X. See section
on p.
