Doc Q7.0
63
Dual Delay
5.6.3
This is a stereo-in/stereo-out delay with fully independent controls for most L-R parameters.
Figure 5-10 – The Dual Delay Block
TIME L
,
TIME R
– Dual parameters to set the time of the left and right delay lines. When
TIME
is shown in
parenthesis, it is being set automatically by the
TEMPO
parameters (see below). Set
TEMPO
to “NONE” to
regain manual control.
LEVEL L, LEVEL R
– Dual parameters to independently set the volume levels of the dual delay lines.
MASTER PAN
– The panning of each voice is multiplied by this value. A value of 100% will result in each
voice being panned as set in the individual pan controls. A value of 0% will result in both voices being panned
to center. A value of -100% will reverse the position of the voices. You can use a modifier on this parameter to
move the voices around the stereo field in real time.
R TIME RATIO
– Allows the right delay line time to be reduced. Very for subtle
TEMPO
offsets!
TEMPO L, TEMPO R
– Dual parameters to lock the independent
TIME L
and/or
TIME R
parameters in
rhythmic relation to the global tempo. See the
TEMPO
section under the MONO DELAY config (p.61) for more
about the relationship between BPM and delay time in milliseconds.
FEEDBK L->L, FEEDBK R->R
– Dual parameters to independently set the amount of feedback for the left
and right channels, determining the number of repeats heard.
FEEDBK L->R, FEEDBK R->L
– Dual parameters to independently set the amounts of cross feedback for
the delay lines. This controls how much of the left delay line is fed back into the right and vice versa.
Negative values phase invert the signal in the feedback loop.
PAN L, PAN R
– Dual parameters to independently set the pan positions of the dual delay lines.
DRIVE
– Sets the amount of distortion in the delay path.
BIT REDUCTION
– Sets the number of bits to be subtracted (from 24 bits), enabling lo-fi effects.
