54
FAULT
POSSIBLE CAUSE
TROUBLESHOOTING
Your machine vibrates.
The feet have not been adjusted.
Adjust the feet. (**)
Transit bolts fitted for transportation
have not been removed.
Remove the transit bolts from the
machine. (**)
Small load in the drum.
This will not prevent operation of
your machine.
Your machine is overloaded with
laundry or laundry is unevenly
spread.
Do not overload the drum. Spread
laundry evenly in the drum.
Your machine rests on a hard surface
Do not set up your Washing Machine
on a hard surface
Excessive foam is formed in the
detergent drawer.
Excessive amount of detergent used.
Press the Start/Pause button. To stop
the foam, dilute one tablespoon of
softener into 1/2 liter of water and
pour into the detergent drawer.
Press the Start/Pause button after 5-
10 mins.
Wrong detergent used.
Only use detergents produced for
automatic Washing Machines.
Unsatisfactory washing result
Your washing is too dirty for the
program selected.
Use the information in the program
tables to select the most appropriate
program.
Amount of detergent used
insufficient.
Use the amount of detergent as
instructed on the packaging.
There is too much laundry in your
machine.
Check that the maximum capacity for
the selected program has not been
exceeded.
Hard water.
Increase the amount of detergent
following the manufacturer’s
instructions.
Your laundry is too tightly packed
together in the drum.
Check that your laundry is spread
out.
As soon as the machine is loaded
with water, water discharges.
The end of water drain hose is too
low for the machine.
Check that the drain hose is at a
suitable height.
No water appears in the drum during
washing.
No fault. Water is in the unseen part
of the drum.
. . . . . . . . . . . . . . . . . . . . .
Laundry has detergent residue.
Non-dissolving particles of some
detergents may appear on your
laundry as white spots.
Perform an extra rinse or clean your
laundry with a brush after it dries.
Grey spots appear on the laundry.
There is untreated oil, cream or
ointment on your laundry.
Use the amount of detergent as
instructed on the packaging in the
next wash.
The spin cycle does not take place or
takes place later than expected.
No fault. The Unbalanced load
control system has been activated.
The Unbalanced load control system
will try to spread your laundry. The
spinning cycle will begin once your
laundry is spread. Load the drum
evenly for the next wash.
