12
ZMI
_001_
2000
1038
01-A
Q
CT0029
_#SE
N
_#AQ
U
_#V
1.f
m
21. Replacing a filter
Water volume regulator filter
21.1
Remove the shower panel (see
21.2
Unscrew the locking screws (a) on the water volume regulators.
21.3
Replace the filters (b).
☞
Important!
Note the installation position of the filters.
21.4
Reassemble in reverse order.
22. Flow quantity regulator Exchanging the flow quantity regulator
22.1
Use a face spanner to loosen the retaining ring and remove it.
22.2
Remove the following parts from the shower head.
a: Ball
b: Seal
22.3
Replace the flow rate regulator (c).
23. Troubleshooting
If you cannot rectify a fault or if it is not in the list, please contact our customer
service department!
Fault
Cause
Remedy
Water does not flow
– Water supply interrupted
➯
Restore it
– Water volume regulator closed
➯
Open it
– Power supply interrupted
➯
Restore it
– Dirty filters
➯
Replace it
– Solenoid valve faulty
➯
Replace it
– Sensor faulty
➯
Replace it
Water flows
continuously
– Solenoid valve faulty
➯
Replace it
Flow time too short or
too long
– Incorrect flow time setting
➯
Set it
Water volume too low
– Water volume regulator not fully open
➯
Open it
– Shower head calcified
➯
Clean it
– Dirty filter
➯
Clean it
– Supply pressure too low
➯
Check it
