9
ZMI
_001_
2030
0085
26-A
Q
LT
0085
_#SE
N
_#AQ
U
_#V1
.f
m
15. Maintenance and Servicing
Depending on the quality of the water, the local conditions and the rules and regula-
tions applicable on site, the fitting must be maintained and serviced at regular
intervals.
Perform maintenance on the following components:
• Filters (see
• Functional part (see
Properly use suitable cleaning agents that are not harmful to the fittings and rinse
with water after use. High-pressure cleaners must not be used for cleaning.
Removing the Fitting
Some maintenance work requires the fitting to be removed.
15.1
Use an Allen key to close the water volume regulator (see
15.2
Trigger the fitting.
15.3
Loosen the union nut (b).
15.4
Remove the fitting.
16. Replacing the Laminar Flow Control
16.1
Use an open-end spanner to unscrew and replace the laminar flow control (a).
16.2
Replace the laminar flow control.
