10
Fig. 1
Fig. 2
SECTION
B
1.
USE MODALITY BY THE CLIENT
Verify with the client the exact operating procedure:
Open the water (max bolt) switch on the machine, push the organic material inside the grinding chamber. At the end of
the grinding, flush the water with switched on machine for few seconds, switch off the disposer and close the water.
2.
REMOVE ANTI-FLOW BULKHEAD
On different types of 2/3 ways drain traps, there is an inside anti-flow bulkhead to the level of the central coupler.
Disassemble the draining-trap with the help of a proper tool, remove this membrane that reducing the useful diameter
section might cause obstruction in this point (fig.3)
Fig. 3
BULKHEAD TO BE REMOVED
3.
USE MORE WATER (AVOID THE DRY USE)
It is very important to do not load the grinding chamber before the water opening and the start up of the disposer.
In this case, or in case of using small quantity of water, it will become a mixture of a difficult scavenging or a possible
obstruction.
PREVIOUS DOCUMENT
START
