3
ELECTRICAL SAFETY
CAUTION
Make sure all ELECTRICAL POWER IS
OFF before connecting any electrical wires.
WARNING
Capacitor voltage may be hazardous.
To discharge motor capacitor, hold insulated handle
screwdriver BY THE HANDLE and short capacitor
terminals together. Do not touch metal screwdriver
blade or capacitor terminals or electrical shock could
occur. If in doubt, consult a qualifi ed electrician.
Wire motor for correct
voltage. See “Electrical
Installation” section of this
manual and motor nameplate.
Ground motor
before connecting to
power supply.
Meet National Electrical
Code (NEC) or Canadian
Electrical Code(CEC) and
local codes for all wiring.
Follow all pump wiring
instructions provided in
this manual.
CAUTION
DO NOT touch an operating motor.
The
surface of the motor may be HOT. Allow the motor to
cool for thirty (30) minutes before handling.
GENERAL SAFETY
• Do not allow pump or any system component to
freeze. To do so will void the warranty.
• This pump has been evaluated for pumping
water only. Pumping liquids other than water may
void warranty.
• Periodically inspect pump and system components.
Hazardous voltage.
Can shock, burn, or
cause death.
Ground pump before
connecting to power
supply. Disconnect
power before working
on pump, motor
or tank.
WA R N I N G
INTRODUCTION
You have purchased one of the most user friendly
pumps available. The Turf Boss pumps are made with
high quality materials which are designed to provide
you with years of reliable service. Lawn sprinklers are
designed to maximize output fl ow, while still maintaining
the ability to draw water from a source up to 25 feet
below the pump. All mechanical parts, motor, impeller,
electrical controls, etc., are above ground within easy
reach. If service is ever necessary, simple hand tools will
do the job. This lawn sprinkler pump installs easily and
quickly without the need for special tools or pump rigs.
You can install it yourself provided you follow closely the
instructions contained in this manual.
INSpECT YOUR SHIpMENT
All Turf Boss lawn sprinkler pumps are carefully tested,
inspected, and packaged to insure their arrival in
perfect condition. When the pump is received, examine
it closely to make sure there is no damage or broken
parts that may have occurred in shipping. If damage
is evident, report this immediately to your shipping
carrier and dealer. This shipping carrier assumes full
responsibility for the shipment’s safe arrival. Any claim
for damage to the shipment, either visible or concealed,
must be made through the shipping carrier fi rst.
pRE-INSTALLATION CHECK
• Pump must not be more than 25 feet above the
surface of the water.
• Use as few elbows and fi ttings as possible to
reduce friction and maximize fl ow.
• Be sure pipe, fi ttings, and foot valve are clean
and free of debris.
• There should be no air pockets or leaks in the
suction pipe.
• PTFE tape should be used to seal threaded pipe
connections.
Summary of Contents for TurfBoss
