Franklin Fueling Systems TS-RA1, Installation Manual

3 

Mounting the Units

• Mount the TS-RA1, and/or TS-RK units through the four (4) 

mounting holes provided in the case under the front cover.

4.22"

107 mm

Internal View (Cover Removed)

EXT

ALARM

CON.

110 VAC 

(NEUT)

(LINE)

110 VAC 

GND

(4) Holes for 

#8-32 Mounting Screws

4.22"

107 mm

G1

(Flasher)

Figure 2: TS-RA1 Mounting Details 

4.22"

107 mm

4.22"

107 mm

Internal View (Cover Removed)

(4) Holes For 

#8-32 Mounting Screws

NEUTRAL

1-2

LATCH

MODE

ACKN

SWITCH

REMOTE

ALARM

SIGNAL

FLASH

SHUNT

FLASH

DRIVE

OUTPUT
OUTPUT

RETURN

GROUND

1-7

1-9

1-8

1-6

1-5

1-4

1-3

F1

LINE

1-1

2-1

2-2
2-3

2-4

Figure 3: TS-RK Mounting Details

•   Mount the TS-RA2 unit through the two (2) mounting 

holes provided.

0.25 DIA (6.4 MM)

  (2) HOLES

5.0"

127 mm

Figure 4: TS-RA2 Mounting Details

Wiring the Units

Materials Required

•   Wire: 18 to 14 AWG, 300 Volt, type TFFN, THWN, 

or THHN (Note: THHN is not available in 18 AWG). 

Recommended insulation colors are black, white, green, 

and blue.

•   Conduit: 1/2 inch, or 3/4 inch (the TS-RA2 has a 1/2 inch 

NPT for threaded conduit / fitting).

•   Fittings: for conduit used, and conduit hold-down clamps.
•   Sealant: waterproof conduit, fittings, fitting threads, and 

conduit accesses to the building.

•   Fasteners: appropriate for the wall construction involved.
Refer to the schematics on the following page for 

connection information.