Operation and Maintenance Manual, OnyX Sky Heat Recovery Units, 2022/01
Frapol Sp. z o.o. reserves the right to introduce changes without any prior notice.
Page
28
•
Advanced control panel (optional equipment)
Disconnect the mounting frame (1) from the rear panel housing (2). The frame is fixed to the panel housing with latches.
You can use a flat screwdriver to detach the frame.
Follow the key (5) to plug the transmission wire conductors (YTKSYekw 2x2x0.8), connecting the panel with the
controller, into the screw terminal (4). The wire connecting the panel with the controller may be recessed in the wall
or may run on its surface
–
in the latter case, the wire should be additionally placed in the cable duct (6) of the mounting
frame. -
Do not route the wire connecting the panel to the controller together with the building’s electrical system cables.
The cable must not be routed in the vicinity of any equipment that emits strong electromagnetic fields either.
Drill the holes in the wall and use the screws (max. Ø 3 mm) to fix the mounting frame on the selected place on the wall
maintaining its proper position (UP). The spacing of the holes can be determined by placing the frame on the wall. Then
attach the panel to the mounting frame using latches.
•
Internal module
When installing the controller module ensure that
- It provides a protection rating appropriate to the environmental conditions, under which the module will be used.
CAUTION
Keep a safe dista
nce of ≥ 1cm between terminals of the module and the conductive components of the
enclosure
-
Do not route the wire connecting the panel to the controller together with the building’s electrical system cables.
The cable must not be routed in the vicinity of any equipment that emits strong electromagnetic fields either.
The connection wires are protected against being torn out, loosened, or exposure to stress.
Sample installation of the module in the casing.
NOTE
The degree of protection of an uninstalled module is IP00.
