Operation and Maintenance Manual, OnyX Sky Heat Recovery Units, 2022/01
Frapol Sp. z o.o. reserves the right to introduce changes without any prior notice.
Page
4
INTENDED USE OF THE UNIT
Operate the equipment according to its intended use and design, as well as within its operating parameters. In the event
of improper use, the manufacturer shall not be held liable for any consequences resulting from such misuse.
PACKAGING
Packaging parts (plastic film, polyester foam, nails, etc.) are hazardous and should be stored away from children, and
disposed of after use in accordance with applicable regulations.
2.
Declaration of the Manufacturer
The Manufacturer declares that the equipment meets the safety requirements of the following directives and associated
standards:
•
2004/108/EC
•
2006/42/EC
•
2006/95/EC
•
2009/125/EC
The sub-assemblies delivered by suppliers have the appropriate declarations of conformity and/or the CE marking in
accordance with the following directives:
•
97/23/EC
In order to meet the basic requirements of EMC 2004/108/EC, the unit must be installed using professional engineering
methods, ensuring electromagnetic compatibility, taking into account information on the use of components for its
intended purpose, and meeting the requirements of the EMC Directive.
This declaration applies only if the unit has been installed in accordance with the Operation and Maintenance Manual
and no changes have been made.
2.1
Residual hazards
In the process of designing and manufacturing the equipment, solutions were applied that minimise possible hazards
to persons and property. However, this does not eliminate all possible risks. Below is the list of some events outside the
control of the manufacturer, which may cause potential risk to human health and security of property:
HAZARDS RESULTING FROM INCORRECT INSTALLATION AND ASSEMBLY
•
accumulation and leakage of condensate (damage to property, short-circuit)
•
leakage of water from the circuit (damage to property, short circuit)
•
falling of the appliance installed on an unsuitable substructure (danger to health and life, damage to
property),
•
installation in a place accessible to unauthorised persons (danger to health and life).
HAZARDS RESULTING FROM INCORRECT TRANSPORTING
•
falling or overturning of the appliance in transport (danger to health and life, damage to property).
HAZARDS RESULTING FROM INCORRECT ELECTRICAL INSTALLATION
•
short-circuit, fire, toxic fumes (danger to health and life, damage to property).
OPERATION WITHOUT PROTECTIVE PANELS AND GUARDS IN PLACE
•
contact with moving or hot parts (danger to health and life).
3.
General information
This OMM provides information concerning the installation, start-up, operation and maintenance of the FRAPOL OnyX
Heat Recovery Units. Read the instructions and recommendations, before carrying out any operation on the device.
Damage to the unit resulting from failure to observe the instructions
–
in particular due to improper storage or
transport, incorrect connections and negligence in maintenance
–
shall not be covered by warranty repairs.
NOTE
The warranty does not cover materials and consumables, in particular: air filters and bearings for fans.
