wind or human activities, it will need to be fastened. It is
suggested to use Method B to install L-shaped support
(1). The specific method is: drill two circular holes with
diameter of X mm and depth Y mm, and use two
expansion tubes and grub screws to fix U-shaped
fastener (4) on the wall, then use two screws to fix
L-shaped support (1) on the U-shaped fastener. But
before doing this, do not forget to connect plug (4) with
socket (3) as shown in the above figure:
3. Fix the lamp
a. Connect power wire to the lamp:
After ensuring the
L-shaped support is well suspended on the wall, insert the
plug (2) of the built-in wire into the socket (1) on the top of
the lamp (3):
b. Fix lamp:
lift the lamp (3) up so that the upper part of the
plug (2) and its wire can enter into the hole of the hold-nut
(2), and turn the hold-nut (2) to let it tightly fit the thread of
the upper part of the lamp until the lamp and L-shaped
support to be fixed as a whole. Meanwhile, adjust the
direction of the lamp until it is satisfied.
Note:
#1.
The
hold-nut must be screwed tightly. #2
.
The lamp holder is
fragile,
use caution so it doesn’t fall on ground.
4. Power on and examination
a
．
Power on:
connect the plug (5) of power wire (6) with
the socket (8) of adaptor (7). If the power wire (6) is not long
enough, add extended wire (8) between those two and
connect (5) and (6), (7) and (8) separately. After that,
connect the adapter (7) with main power supply.
b. Examination:
there is a switch at the bottom of the lamp
(3) (see the following figure). Turn on the switch to left side;
the lights should be twinkling, snow flying around and
music playing. If the above are not functioning, check that
the connections are done properly
. You can also turn the
switch to right side to turn off the music.
5. Attention
Please pay special attention:
a.
Please fix the hold-nut at the top of lamp securely.
b.
All connection points 1, 2, 3, 4, 5, 6, 7 and 8 must be
screwed securely to avoid water and electricity leakage!
c.
It is best to ensure that the connecting point between
adapter and main power should be located indoors
where it’s free from rain and snow, to avoid the electricity
leakage or electric shock risk.
