1) Schematic diagram
2) Component list
No.
Name
Number
1
Lamp top
1
2
Lamp holder
1
3
Lamp post (17in
）
2
4
Adapter (12V AC 500mA)
1
5
Extended wire (137in)
1
6
Power wire (137in)
(inside lamp post: 59in, outside: 78in)
1
7
Additional base
1 set
（
4
）
8
Ground nail
4
9
Lamp base
1
10
Square base
1
11
Brand
1
12
Lamp post joint
1
13
bowknot
1 set
14
Power wire of lamp holder
1
15
Screw
4+1
Note: 1,2,3,4,5,6 are all wire joints.
3) Assembling steps
Please assemble the product from the bottom to the up,
following the main steps below:
1. Install lamp base
A.
Assemble lamp base (9) and square base (10) with 4
screws:
B.
Assemble 4 pieces of additional base (7) into a whole,
and then assemble the whole additional base (7) with the
lamp base (9).
Note:
The additional base (7) is designed to fasten the
street lamp more securely. If the street lamp is installed on
a flat ground and there is no external force (such as high
wind or man-made interference), or if the street lamp is
used outdoors and it can be fixed on the ground by
fastening ground nails; there is no need to install additional
base (7). In other words, users can decide whether to
install the additional base (7) according to the actual
condition.
2. Install lamp post
Screw the two lamp posts (3), lamp post joints (12) and
square lamp base (10) together according to the sequence
shown in the figure below.
Note:
Every screw thread must
be tightened; otherwise, the lamp posts may lean or get loose.
Caution
This product (especially the lamp holder) is
fragile, do not exert too much strength or drop it
during the assembly and use. Be sure to fix it on
the wall securely.
Please assemble it in strict accordance with
the steps and requirements specified in the
instruction to ensure safety and reliability
during the installation.
