12
While doing this take care to not sand the two wooden pins on top as they are
needed to center the elevator.
No wrap some sanding paper around the boom (ca. 6 to 8 cm in front of the
rudder slot) no gently sand the pylon bottom to the shape of the boom.
Now we suggest to cover the pylon and the elevator with the fabric of your
choice.
Put the elevator on the pylon and fix it with the 2.9 x 13mm screw. Also mount
the wing onto the fuselage. Align the elevator with the wing center panel and
glue the pylon on the boom (Epoxy). The distance between the rudder and the
trailing edge of the elevator should be approximately 10mm.
Slide the rudder into the slot and make sure that the two marks on the rudder
align with the boom. Additionally make sure that the rudder hinge line is
exactly vertical. When achieved you can glue (Super Glue or Epoxy) the rudder
to the tail boom (if everything was done properly before you should have an
exact angle of 90 degrees between elevator and rudder). The rudder can now
be covered.
As a last step you need to bend two ca. 5cm long springs out of the 0.5mm
wire. The torsion angle should be +/- 100 degrees.
Mount the springs to the rudder and elevator.
Summary of Contents for Fun-RES
Page 4: ...4 3 Wooden parts...
