7
The joiner is the only connection between the main wing panel and the tips.
The two panels will be secured with crystal tape for flying. Although not
needed an additional hesitation pin can of course be installed by yourself.
Remove the tips from the main
wing panel. Now you can glue
the outer tips on the inner tips.
This is also best done with Epoxy.
To assure the correct dihedral
put a 85mm balsa block under
the end of the outer wing panel
while curing.
For the spoiler linkage, glue (or tape) the servo to the bottom
side of the wing. For the linkage itself use a 0.5 mm steel wire.
Lightly sand all wing surfaces (especially the glued joints and the carbon
reinforced areas) to get a smooth surface. Now the wing is ready to get
covered with the foil of your choice.
Summary of Contents for Fun-RES
Page 4: ...4 3 Wooden parts...
