PRO-S Rev1104
20
High Idle Option Calibration
The RPM that the engine will run at when the high idle circuit is engaged is set by
adjusting the 2500 ohm potentiometer.
1. Loosen the lock nut on the potentiometer.
2. Place the high idle switch to ON.
3. With a small screw driver adjust the wiper arm on the potentiometer to set the
engine RPM. (Use a reference tachometer monitor engine speed.)
4. Tighten the lock nut on the potentiometer. Ensure the engine RPM does not
change when the lock nut is tightened.
5. Place the high idle switch to OFF.
3rd Gear Lock-up RPM Calibration (Ford 6.0L)
The 3rd gear lock-up is factory set at 1200 RPM. This procedure is to change the
setting in the program.
Note: The engine must be running and the pump engaged interlock circuit
must be closed.
1. Press
IDLE
button.
Result:
SETTING
display shows
IdLE
.
2. Press
RPM
mode button to select RPM mode.
Result:
RPM
LED indicator goes on.
Note: The
RPM
display must show
IdLE
.
3. Press and hold
PRESET
button. (Continue to hold through step 5.)
Result:
SETTING
display flashes the programmed preset.
4. Press and release
RPM
mode button.
Result:
SETTING
display shows programmed lock-up RPM.
5. Press
INCREASE
or
DECREASE
button to change RPM setting.
6. Release
PRESET
button.
Result: The new 3rd gear lock-up RPM is programmed.
SETTING
display
shows
IdLE
.
