WLA300 Rev170606
17
Pattern 1
Pattern 2 Pattern 3 Pattern 4 Pattern 5 Pattern 6
3. Swipe the magnet once and in five seconds the previously saved color pattern will
be displayed. The Red LEDs will all light up and scroll upward (as shown in Pattern
10). The Red LEDs scrolling upward means the MaxVision display is synchronized
with the primary display. The color pattern on the MaxVision will be identical to
the one on the primary display. (This is the default setting).
Each swipe changes the choice from each of the nine color patterns—the nine
options are stepped through and then repeated.
4. Hold the magnet over the calibration point for five seconds to save the new color
pattern setting. The display flashes or blinks three times to confirm setting is saved
and updated.
Pattern 10
Pattern 7
Water
Pattern 8
Foam A
Pattern 9
Foam B
Red LEDs Scrolling Upward—
symbolizes the color pattern on
MaxVision is synchronized with
the color pattern on the primary
display (default color pattern
setting for MaxVision)
Figure 5. MaxVision Color Pattern Programming
Note
: Reset the power if Pattern
#10 is selected and saved.
Summary of Contents for TankVisionPro WLA300
Page 43: ...WLA300 Rev170606 43 NOTES ...
Page 44: ...WLA300 Rev170606 44 ...
