Fredenstein Bento 10D Rev. A Module Carrier
If certain non-Fredenstein modules are used, which bridge several pins on the connector and
connected the contacts on the top and button side, the double switches, located directly besides the
slot connectors, can both be turned off (lower position) to avoid interference between the module
and the digital interconnect. For Fredenstein modules, both need to be in the ON (upper) position.
Operation:
After installation of the modules, connect the mains cord to the Bento 10D IEC socket located on
the back-panel and than connect the mains cable to a grounded outlet. Now turn the Bento 10 on by
operating the I/O switch (also part of the IEC socket on the back). The following screen will be
displayed indicating the status and power-supply voltages.
Now the Bento 10D is ready and will display any request from certain
Fredenstein modules.
To enter the setup menu, please push the wheel and the setup menu will
appear.
Configuration of audio linking
Configuration of compressor buss linking
Save Configuration
Recall Configuration
Enable/disable ground lift
Set display brightness and dimming
Exit menu system
Turning the wheel left or right to scroll from one menu point to the next, the highlighted menu point
will get selected when the wheel is pushed. Selecting Exit and pushing the wheel will show the
Status screen again.
Fredenstein Bento 10D Rev. A Manual V1.1 APR 8, 2015 Page 2
