7
5. While another person holds the Console (16) in the
position shown, connect the wire harness on the
Console to the Upper Wire Harness (36). Insert the
excess wire harness into the Upright (13).
Attach the Console (16) to the Upright (13) with four
M4 x 16mm Screws (66).
Be careful to avoid pinch-
ing the wire harnesses.
7. Turn the indicated Adjustment Knob (28) counterclock-
wise two or three turns to loosen it. Next, pull the Knob,
insert the Seat Post (5) into the Frame (1), and then
release the Knob.
Move the Seat Post up and down
slightly until the pin on the Knob snaps into one of
the holes in the Seat Post.
Then, turn the Knob clock-
wise until it is tight.
1
5
28
4. Slide the two Handlebar Collars (7) onto the Left
Handlebar (50). Insert the Right Handlebar (51) into
the Left Handlebar. Connect the Handlebar Collars, the
Left Handlebar, and the Right Handlebar with two M4 x
16mm Screws (66).
Attach the Handlebar Bracket (15) to the Left and
Right Handlebars (50, 51) with four M8 x 22mm Button
Screws (74).
Attach the Handlebar Bracket (15) to the Upright (13)
with two M8 x 39mm Button Bolts (64), two M8 Nylon
Locknuts (10), and an M8 x 14mm Button Screw (49).
64
66
66
7
7
10
49
4
7
15
13
74
74
50
51
5
16
13
66
66
36
Wire
Harness
6. The Console (16) requires four “D” batteries (not
included); alkaline batteries are recommended.
Remove the indicated screw from the battery drawer,
and pull the battery drawer open. Insert four batteries
into the battery drawer;
make sure that the batteries
are oriented as shown by the markings inside the
battery drawer.
Close the battery drawer and reattach
the screw. Note: When the batteries are installed cor-
rectly, the fan will turn on for a moment.
16
Batteries
Battery
Drawer
6
Screw
