19
EN
5
Using Freecom Turbo USB 2.0 (only PC)
Chapter 5: Using Freecom Turbo USB .0 (only PC)
By installing the Turbo USB 2.0 driver for your ToughDrive, the data transfer rate can be
significantly increased (up to 40% faster transfer speed compared to standard High-
Speed USB).
Enabling the Turbo USB .0 driver
1. Connect the Freecom ToughDrive to your PC.
2. Run “Start.exe” from your ToughDrive and go to Software Installation -> Freecom
Turbo USB 2.0.
3. The Freecom Turbo USB 2.0 Wizard will open.
4. Check the drive and click on “Configure” to enable the Turbo USB2.0 driver for the
Freecom ToughDrive.
Disabling the Turbo USB .0 driver
5. Connect the Freecom ToughDrive to your PC.
6. Run “Start.exe” from your ToughDrive and go to Software Installation -> Freecom
Turbo USB 2.0.
7. The Freecom Turbo USB 2.0 Wizard will open. Uncheck the drive and click on “Configure”
to disable the Freecom Turbo USB 2.0 driver for the Freecom ToughDrive.