7 |
P a g e
Rev 05/2015
MAINTENANCE
Please make sure that the
power is disconnected before doing any maintenance.
(1).
Keep the bathtub clean and neat
(2).
DO NOT use strong acids or alkali liquids to clean the bathtub or fixtures
(3).
DO NOT allow the tub to run for more than 3 hours continuously
(4).
When cleaning the shell and floor of the bathtub, please use the soft and dry cloth. If there is light amount of dirt, use the soft
cloth or sponge to clean with a non
-
abrasive cleaning. Use alcohol to remove stubborn stains.
(5).
Use a detergent
that is specially made for acrylic tubs. The following substances are not to be used: acids or alkali solutions,
acetone product. If these products are used, damage to the tub and accessories may occur and the warranty will be void.
(6).
Don’t use sharp obje cts to hit or strike the surface of the acrylic, glass and metal parts to avoid damaging the finish. Don’t use
coarse or abrasive cleaners to clean the surface of acrylic, glass and metal parts to avoid damaging the surface.
(7).
Frequently check power lines, switches, water supply lines, drain pipes for possible damage. Replace as needed.
TROUBLESHOOTING GUIDE
Problem
Cause
Solution
Pump does not work
1.
The fuse is tripped due to short circuit
or overload
2.
Control system malfunction
1.
Check the circuit and reset
(or replace
fuse if needed)
2.
Contact supplier
Pump is making strange noises
1.
Pump inlet may be blocked
2.
Water Pump bearing may be cracked
3.
Pump overloaded
1.
Switch off power to stop the operation,
replace pump if needed
2.
Contact supplier
GFCI breaker / outlet trips
Short circuit or other electrical issues
Check the circuit . Replace or repair
defective part
Water from door
The door seal is cracked or torn
Replace the seal
