3
STEP 1 -
Attach the 2 Plastic U Clamps to the bottom of each of the back post tubes
and tighten screws. (Recommended torque setting 2-3N-m)
STEP 2 -
Position the fully assembled Easy Back system on the bottom locations
(Figure 1), slide the back into position between the back posts.
STEP 3 -
Attach the 2 Quick Release Frame Clamps to the top of the back post tubes.
Lower into position on top of the J Hook and turn lever to locked position.
(Figure 2) Finally, tighten screws. (Recommended torque setting 4-6N-m.)
STEP 4 -
Tighten all screws on hardware.
Figure
1
Figure
2
The Easy Back has 3 depth adjustment settings, see Figure 3. Use two adjacent hole
positions to give a range of up to 50mm of depth adjustment. Tools required 4mm or
5/32” allen key and 11mm or 7/16” spanner.
Figure 3
INSTRUCTIONS FOR ASSEMBLY TO 7/8” (22MM) & 1” (25.4MM) BACKPOST TUBES
DEPTH ADJUSTMENTS
Note: Do not
attempt to
adjust this
screw
Depth Adjustment
