5
2. HOW TO DISASSEMBLE
To disassemble just reverse the process of the assembly.
You must turn off power
before starting to dismantle the scooter.
a)
Turn off the power and take out the power key from switch lock.
b)
Loosen and Remove the seat from the seat post.
c)
Carefully remove the rear fairing to allow for access to the rear fairing lights
connector.
d)
Disconnect the rear fairing lights and completely remove the rear fairing.
e)
Undo all battery terminal connections.
f)
Remove the batteries from the floor pan.
g)
Fold down the tiller to horizontal.
V.
OPERATING YOUR SCOOTER
a)
BEFORE OPERATION
a.
Insert the power key into the switch lock and turn clockwise to the ON
position.
b.
Check the battery charge indicator to make sure the batteries are fully
charged.
c.
Make sure that neutral clutch lever is not engaged at the closed position.
b)
TURN POWER ON
a.
Insert the key into the key switch on the upper tiller and rotate clockwise to
the “ON” position.
c)
FORWARD MOTION
a.
To move forward, pull the right thumb lever under the control console
towards you.
b.
The further you pull, the faster the scooter will go. The maximum speed
may be selected by the speed selection dial located in the middle of the
control console.
