freeGuard 100 CLI User Manual
113
The configrouter ospf command has 7 subcommands.
config area
config distribute-list
config neighbor
config network
config ospf-interface
config redistribute
config summary-address
Note:
In the following table, only the router-id keyword is required. All other keywords are optional.
ospf command keywords and variables
Keywords & Variables Description
Default
abr-type {cisco | ibm |
shortcut | standard}
Specify the behavior of a freeGuard 100 acting as an OSPF
area border router(ABR) when it has multiple attached
areas and has no backbone connection. Selecting the ABR
type compatible with the routers on your network can
reduce or eliminate the need for configuring andmaintaining
virtual links. For more information, see RFC 3509.
cisco
database-overflow
{disable | enable}
Enable or disable dynamically limiting link state database
size under overflow conditions. Enable this command for
freeGuard 100s on a network with routers that because of
limited resources may not be able to maintain a complete
link state database.
disable
database-overflow-
max-lsas
<lsas_integer>
If you have enabled
database-overflow
, set the limit for
the number of external link state advertisements (LSAs)
that the freeGuard 100 can keep in its link state database
before entering the overflow state. The
lsas_integer
must be the same on all routers attached to the OSPF area
and the OSPF backbone. The valid range for
lsas_integeris
0 to 4294967294.
10000
database-overflow-
time-to-recover
<seconds_integer>
Enter the time, in seconds, after which the freeGuard 100
will attempt to leave theoverflow state. If
seconds_integer
is set to 0, the freeGuard 100 will not
leave the overflow state until restarted. The valid range for
seconds_integer
is 0 to 65535.
300
default-information-
metric <metric_integer>
Specify the metric for the default route set by the
default-information-originate
command. The
valid range for
metric_integer
is 1 to 16777214.
10
default-information-
metric-type {1 | 2}
Specify the OSPF external metric type for the default route
set by the
default-information-originate
command.
2
Summary of Contents for freeGuard 100
