freeGuard 100 CLI User Manual
117
never}
LSAs used for distributing external route information to
other parts of the OSPF routing domain. Usually a NSSA
will have only one NSSA border router acting as a
translator for the NSSA. You can set the translator role to
always to ensure this freeGuard 100 always acts as a
translator if it is in a NSSA, even if other routers in the
NSSA are also acting as translators. You can set the
translator role to candidate to have this freeGuard 100
participate in the process for electing a translator for a
NSSA. You can set the translator role to never to ensure
this freeGuard 100 never acts as the translator if it is in a
NSSA.
shortcut {default |
disable | enable}
Use this command to specify area shortcut parameters.
disable
stub-type {no-summary
| summary}
Enter no-summary to prevent an ABR sending summary
LSAs into a stub area. Enter summaryto allow an ABR to
send summary LSAs into a stub area.
summary
type {nssa | regular |
stub}
Set the area type:
• Select nssa for a not so stubby area.
• Select regular for a normal OSPF area.
• Select stub for a stub area.
regular
Example
This example shows how to configure a stub area with the id 15.1.1.1, a stub type of summary, a
default cost of 20, and MD5 authentication.
config router ospf
config area
edit 15.1.1.1
set type stubset stub-type summary
set default-cost 20 set authentication md5
end
end
This example shows how to display the settings for area 15.1.1.1.
config router ospf
config area
edit 15.1.1.1
get
end
Summary of Contents for freeGuard 100
