freeGuard 100 CLI User Manual
143
Keywords & Variables Description
Default
default-information-
originate {disable |
enable}
Enter enable to advertise a default static route into RIP.
disable
default-metric
<metric_integer>
For non-default routes in the static routing table and directly
connected networks the default metricis the metric that the
freeGuard 100 advertises to adjacent routers. This metric is
added to the metrics of learned routes. The default metric
can be a number from 1 to 16.
1
garbage-timer
<timer_integer>
The time in seconds that must elapse after the timeout
interval for a route expires, before RIP deletes the route. If
RIP receives an update for the route after the timeout timer
expires but before the garbage timer expires then the entry is
switched back to reachable. RIP timer defaults are effective
in most configurations. All routers and access servers in the
network should have the same RIP timer settings.
120
passive-interface
<name_str>
Block RIP broadcasts on the specified interface. You can use
“config neighbor” and the passive interface command to
allow RIP to send unicast updates to the specified neighbor
while blocking broadcast updates on the specified interface.
No default.
timeout-timer
<timer_integer>
The time interval in seconds after which a route is declared
unreachable. The route is removed from the routing table.
RIP holds the route until the garbage timer expires and then
deletes the route.If RIP receives an update for the route
before thetimeout timer expires, then the timeout-timer is
restarted. If RIP receives an update for the routeafter the
timeout timer expires but before the garbage timer expires
then the entry is switched back to reachable. The value of
the timeout timer should be at least three times the value of
the update timer. RIP timer defaults are effective in most
configurations. All routers and access servers in the network
should have the same RIP timer settings.
180
update-timer
<timer_integer>
The time interval in seconds between RIP updates. RIP timer
defaults are effective in most configurations. All routers and
access servers in the network should have the same RIP
timer settings.
30
version {1 2}
Enable sending and receiving RIP version 1 packets, RIP
version 2 packets, or both for all RIP-enabled interfaces. You
can override this setting on a per interface basis using the
receive-version {1 2} and send-version {1 2} keywords
described under “config interface” on page 182.
2
Example
This example shows how to:
Summary of Contents for freeGuard 100
