freeGuard 100 CLI User Manual
213
• tzo.com supports rh.tzo.com.
• vavic.com supports ph001.oray.net.
ddns-sn <sn_str>
Enter your DDNS serial number. This keyword is available instead
of ddns-username and ddns-password if ddns-server is set to
dipdns.net.
No default.
ddns-username
<name_str>
Enter the user name to use when connecting tothe DDNS server.
No default.
defaultgw {enable |
disable}
Enable or disable the interface as the default gateway.
disable
detectserver
<address_ipv4>
Add the IP address of a ping server. A ping server is usually the
next hop router on the network connected to the interface. If
gwdetectis enabled, the freeGuard 100 confirms connectivity with
the server at this IP address. Adding a ping server is required for
routing failover.
No default.
dhcp-relay-ip
<address_ipv4>
Set the DHCP relay IP address. Must not be set to 0.0.0.0.
No default.
dhcp-relay-type
{ipsec | regular}
Set DHCP relay to relay either IPSec or regular firewall traffic.
regular
dhcp-server-mode
{none | relay |
server}
Set the interface to act as a DHCP server, or relay agent, or not to
provide DHCP services. A freeGuard 100 interface can act either
as a DHCP server or as a DHCP relay agent but not both. In a
DHCP relay configuration, the freeGuard 100 forwards DHCP
requests from DHCP clients through the freeGuard 100 to a DHCP
server. The FreeGuard 100 also returns responses from the
DHCP server to the DHCP clients. The DHCP server must have a
route to the freeGuard 100 configured as the DHCP relay so that
the packetssent by the DHCP server to the DCHP client arrive at
the freeGuard 100 performing DHCP relay.
For more information on DHCP server configuration, see “dhcp
server”
none
except
server for
internal
interface
disc_retry_timeout
<seconds_integer>
Set the initial discovery timeout in seconds. The time to wait
before retrying to start a PPPoE discovery. Set disc_retry_timeout
to 0 to disable.
1
distance
<distance_integer>
Configure the administrative distance for routes learned through
PPPoE or DHCP. Using administrative distance you can specify
the relative priorities of different routes to the same destination. A
lower administrative distance indicates a more preferred route.
Distance can be an integer from 1-255. See also static “distance
<distance_integer>”
1
dns-server-
override {enable |
disable}
Enable to allow the interface to use DNS server addresses it
acquired via DHCP or PPPoe.
disable
gwdetect {disable |
enable}
Enable or disable confirming connectivity with theserver at the
detectserver IP address. The frequency with which the freeGuard
disable
Summary of Contents for freeGuard 100
