freeGuard 100 CLI User Manual
235
status {disable |
enable}
Enable or disable the SNMP community.
enable
trap_v1_lport <local-
port_integer>
SNMP v1 local port number used for sending traps to the
SNMP managers added to this SNMP community.
162
trap_v1_rport <remote-
port_integer>
SNMP v1 remote port number used for sending traps to
the SNMP managers added to this SNMP community.
162
trap_v1_status
{disable | enable}
Enable or disable SNMP v1 traps for this SNMP
community.
enable
trap_v2c_lport <local-
port_integer>
SNMP v2c local port number used for sendingtraps to the
SNMP managers added to this SNMP community.
162
trap_v2c_rport
<remote-port_integer>
SNMP v2c remote port number used for sending traps to
the SNMP managers added to this SNMP community.
162
trap_v2c_status
{disable | enable}
Enable or disable SNMP v2c traps for this SNMP
community.
enable
Example
This example shows how to add a new SNMP community named SNMP_Com1. The default
configuration can be used in most cases with only a few modifications. In the example below the
community is added, given a name, and then because this community is for an SNMP manager that is
SNMP v1 compatible, all v2c functionality is disabled. After the community is configured the SNMP
manager is added. The SNMP manager IP address is 192.168.20.34 and it connects to the freeGuard
100 internal interface.
config system snmp community
edit 1
set name SNMP_Com1
set query_v2c_status disable
set trap_v2c_status disable
config hosts
edit 1
set interface internal
set ip 192.168.10.34
end
end
This example shows how to display the settings for the system snmp community command.
get system snmp community
Summary of Contents for freeGuard 100
