freeGuard 100 CLI User Manual
1
1 Introduction
The freeGuard 100 Unified Threat Management (UTM) Firewall supports network-based deployment
of application-level services, including virus protection and full-scan content filtering. freeGuard 100s
improve network security, reduce network misuse and abuse, and help you use communications
resources more efficiently without compromising the performance of your network.
The freeGuard 100 is a dedicated easily managed security device that delivers a full suite of
capabilities that include:
•
application-level services such as virus protection and content filtering,
•
network-level services such as firewall, intrusion detection, VPN, and traffic shaping.
1.1
About this document
This CLI Reference Guide describes how to use the freeGuard 100 command line interface (CLI). This
document contains the following chapters:
•
USING THE CLI: describes how to connect to and use the freeGuard 100 CLI.
•
CONFIG ALERTMAIL: is an alphabetic reference to the commands used to configure alertemail.
•
CONFIG ANTIVIRUS: is an alphabetic reference to the commands used to configure antivirus
features.
•
CONFIG FIREWALL: is an alphabetic reference to the commands used to configure firewall
policies and settings.
•
CONFIG lOG: is an alphabetic reference to the commands used to configure logging.
•
CONFIG IPS: is an alphabetic reference to the commands used to configure intrusion detection
and prevention features.
•
CONFIG ROUTER: is an alphabetic reference to the commands used to configure routing.
•
CONFIG SPAMFILTER: is an alphabetic reference to the commands used to configure spam
filtering features.
•
CONFIG SYSTEM: is an alphabetic reference to the commands used to configure the freeGuard
100 system settings.
•
CONFIG USER: is an alphabetic reference to the commands used to configure authorized user
accounts and groups.
•
CONFIG VPN: is an alphabetic reference to the commands used to configure freeGuard 100
VPNs.
•
CONFIG WEBFILTER: is an alphabetic reference to the commands used to configure web content
filtering.
•
EXECUTE: is an alphabetic reference to the execute commands, which provide some useful
utilities such as ping and traceroute, and some commands used for maintenance tasks.
Note:
Diagnose commands are also available from the freeGuard 100 CLI. These commands are
used to display system information and for debugging. Diagnose commands are intended for
advanced users only, and they are not covered in this reference guide. Contact freedom9 technical
Summary of Contents for freeGuard 100
