I N T R O D U C T I O N
About Document Conventions
1-2
Security Appliance User Guide
Version 3R2
1
• For commands that require a selection from a pre-defined list of
values, each value in the list is separated by a pipe ( | ).
• Variables appear in italic.
• When a CLI command appears within the context of a sentence in this
document, it is in
bold
(except for variables, which are always in
italic). For example: “Use the
get
system
command to display
general information about the freeGuard Blaze 2100.”
Variable CLI values are described in
Table 1-1
Table 1-1: Variable CLI Values Used in This Guide
BROWSER-BASED GRAPHICAL USER INTERFACE (WEBGUI)
CONVENTIONS
• Values inside square brackets [ ] are optional.
• Values inside braces { } are required.
• For commands that require a selection from a pre-defined list of
values, each value in the list is separated by a pipe ( | ).
• Variables appear in italic.
When a WebGUI command appears within the context of a sentence in
this document, it is in
bold
(except for variables, which are always in
italic
). For example: “Use click on the
XXXX
command to display general
information about the freeGuard Blaze 2100.”
Variable CLI Value
Description
addr_str
Defines an IP address range assignment
dst_adr
Destination address assigned in a policy
fqdn
Fully Qualified Domain Name
ip_addr
Defines an IP address assignment
number
Numeric value assigned for a specific command
name_str
Name value assignment
password_str
New password assignment is required
src_adr
Source address assigned in a policy
srvc
Service assigned in a policy
zone name
Zone used in a specific command
