39
| AIRCRAFT FLIGHT MANUAL
3. Remove or replace the jumper as needed
4. Reattach the closeout panel
MAPPING RADIO CHANNELS USING ALTA APP
Channel mapping is accomplished with the ALTA App. Prior to mapping channels,
ensure your radio controller and receivers are properly installed. Refer to the Radio
Installation section of this manual and your radio controller’s documentation.
1. Remove the Configuration Jumper
WARNING
Always ensure the Configuration Jumper is removed prior to
adjusting radio settings to prevent unintentional motor starts.
2. Power ALTA 8 using a battery pack or by plugging in the included
USB-Futaba cable into an available port on a Futaba receiver
3. Open the ALTA App and connect to ALTA 8
4. Open Configurations > Radio
5. Open each ALTA 8 function and adjust the channel to the desired channel
number, and use the toggle to invert the orientation of a control
6. Ensure proper channel selection by moving the control input on the radio
controller and verifying the displayed graph in the ALTA App responds correctly
WARNING
Ensure proper channel mapping prior to flight. Incorrect mapping
can lead to immediate loss of control.
Summary of Contents for ALTA 8
