CLEANING THE NAIL CHANNEL
MODEL: PE2118G
HTTP://WWW.FREEMANTOOLS.COM
1-888-669-5672
11
MODEL: PE2118G
HTTP://WWW.FREEMANTOOLS.COM
1-888-669-5672
10
Latch
Button(A)
Magazine
Cover(B)
Disconnect the battery from the tool.
Push down on the latch button(A). Pull back on the
magazine cover(B).
Remove fasteners from the magazine.
1.
2.
3.
CLEARING JAMS
Occasionally, a fastener may become jammed in the
firing mechanism of the tool, making the tool inopera-
ble. To remove a jammed fastener, follow the steps
below:
Use pliers to remove jammed fastener from the
drive channel.
4.
Use a screw driver to push the drive blade back
into place.
5.
When you are operating the tool in below freezing
environments:
COLD WEATHER OPERATION
Before using the tool be sure to keep it as warm as
possible
Fire the tool into a scrap piece of material 5 to 6
times.
CLEANING
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents and maybe damaged
by their use. Use clean cloths to remove dirt, dust , oil,
grease, etc.
MAINTENANCE
WARNING:
Any time inspection, maintenance, and
cleaning are done be sure to remove the
battery from the tool and empty all
fasteners from the magazine.
Problems with driving nails or cycling of nails while
firing may be due to glue residue from the nail strips.
If this is the case clean the area around the driving
mechanism.
Remove the tool battery.
Slide magazine cover down to remove nails and
expose the nail channel.
Use a small amount of air tool oil on a clean cloth to
swab and wipe down the nail channel, untill all
traces of glue are removed.
Reinstall nails in the magazine and close the
magazine cover.
1.
2.
To charge the battery line up the slot of the battery
with the slot of the charger and slide into place.
The battery indication light should turn from green
to red when the battery is charging.
When the indication light has turned green the
battery should be fully charged.
1.
2.
3.
CHARGING BATTERY
Battery Slot
Charger Slot
Indication Lights
CHARGING A HOT BATTERY PACK
After a tool has been used for a prolong amount of
time the batteries in the battery pack will become hot.
This only occurs when the tool has been used
continuously for a extended period of time. When the
battery becomes hot let it cool for 30 minutes before
recharging. Refer to the
CHARGING BATTERY
section for normal charging of batteries. If the
charger does not charge your battery under normal
circumstances, contact the authorized dealer.
BATTERIES
These batteries will wear out over time, like all
batteries. If this happens do not disassemble the
battery and attempt to fix it. This could cause serious
burns especially when wearing rings and jewelry. To
have the longest possible battery life, we suggest the
following.
Once a battery pack has been fully charged
remove it from the charger
The battery should be stored in a temperature
that is below 80°F and away from moisture
Batteries should be stored with a 30%-50%
charge
If a battery has been stored for six months or
more charge the battery as normal
BATTERY PACK REMOVAL AND
RECYCLING
Please recycle all worn batteries.
This battery contains lithium-ion
batteries. Local and state
regulations may prohibit disposal
of lithium-ion batteries in
ordinary trash. Consult your local
waste authority for information
regarding available recycling
and/or options.
