6
ASSEMBLY
2
27
3
3
1. Orient the Crossbar (2) as shown.
Attach the Crossbar (2) to one of the Uprights
(3) with two M10 x 80mm Screws (27);
do not
tighten the Screws yet.
Attach the Crossbar (2) to the other Upright
(3) in the same way.
• To hire an authorized service technician to
assemble this product, call 1-800-445-2480.
• Assembly requires two persons.
• Due to its weight and size, the weight bench
should be assembled in the location where it will
be used. Make sure that there is enough clear-
ance to walk around the weight bench as you
assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you
nish all assembly steps.
• Left parts are marked “L” or “Left” and right parts
are marked “R” or “Right.”
• To identify small parts, see page 5.
• In addition to the included tool(s), assembly
requires the following tool(s):
two adjustable wrenches
one Phillips screwdriver
one rubber mallet
Assembly may be easier if you have a set of
wrenches. To avoid damaging parts, do not use
power tools.
1
Warning
Decals
