11
10
10.
Tip: Avoid pinching the wires.
Slide the
Upright (2) onto the Frame (1).
Attach the Upright (2) with four M10 x 16mm
Screws (67) and four M10 Split Washers (100).
Tip: Tighten the two Screws in the front of
the Upright, and then tighten the other two
Screws.
Note: If you purchase the optional chest
heart rate monitor (see page 21), see
step 18 on page 14 to install the receiver
included with the heart rate monitor.
Slide the Top Shield (44) downward and press it
onto the Left and Right Front Shields (13, 14).
Avoid pinching
the wires
2
1
67
67
100
100
13, 14
44
11
11. Identify the Right Handlebar (20) and orient it as
shown.
Attach the Right Handlebar (20) to the Upright
(2) with two M8 x 16mm Screws (69).
Attach the Left Handlebar (7) in the same
way.
7
20
2
69
69
