14
install the receiver included with the heart rate monitor.
18. Note: If you have already assembled the exer-
cise bike, use a flat screwdriver and remove the
Top Shield (44) from the frame.
See the inset drawing.
Remove the paper from
the adhesive pad on the back of the receiver (A).
Orient the receiver so that the antenna on the
receiver is in a horizontal position parallel to
the floor.
Press the receiver onto the indicated
location on the underside of the Accessory Tray
(40).
Next, connect the wire on the receiver (A) to the
Receiver Wire (102) in the Upright (2).
Note: Discard any other wires that are included
with the heart rate monitor.
Note: If you have already assembled the exer-
cise bike, press the Top Shield (44) into place.
18
44
40
2
102
40
A
Antenna
Wire
102
