9
6. Attach the Knuckle Bearing (28) on the lower
end of the Right Upper Body Leg (26) to the
Right Pedal Arm (31) with an M10 x 75mm Bolt
(108), two M10 x 20mm x 2mm Washers (95),
and an M10 Locknut (96).
Repeat this step on the left side of the
elliptical.
6
31
28
26
95
96
95
8.
Make sure that all parts are properly tightened before you use the elliptical.
Note: Extra parts may be
included. Place a mat beneath the elliptical to protect the floor.
7. Identify a Left Pivot Cover (61) and a Right Pivot
Cover (62), and orient them as shown.
Hold the Left and Right Pivot Covers (61, 62)
around the Right Upper Body Leg (26) as shown.
Attach the Left and Right Pivot Covers (61, 62)
with three M5 x 12mm Screws (71);
start all the
Screws, and then tighten them.
Repeat this step on the left side of the
elliptical.
7
71
71
62
61
26
108
