24
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the elliptical is used.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console does not display your heart rate when
you hold the handgrip heart rate monitor, or if the dis-
played heart rate appears to be too high or too low, see
step 5 on page 18.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
CHARGING THE GENERATOR
See EXPLODED DRAWING A on page 29. For the
best results, charge the internal Battery (4) that
powers the Generator (7) once per week. To charge
the Battery, plug the Power Adapter (134) into the
receptacle on the frame of the elliptical.
ADJUSTING THE DRIVE BELT
If the pedals slip while you are pedaling, even while the
resistance is adjusted to the highest setting, the drive
belt may need to be adjusted. Before you adjust the
drive belt, unplug the power adapter.
Remove the two Cover Caps (55) from the Rear
Shield Cover (54). Next, remove the two indicated
M5 x 12mm Truss Screws (68). Then, remove the Rear
Shield Cover.
Next, locate the M8 Locknut (90) on the Eyebolt (8).
Tighten the Locknut until the Drive Belt (16) is tight.
When the drive belt is properly tightened, reattach the
parts that you removed.
55
55
68
54
68
8
90
16
MAINTENANCE AND TROUBLESHOOTING
Summary of Contents for e8.9b
Page 26: ...26 NOTES ...