7
1
1.
Orient the Upright (72) as shown.
Have a sec-
ond person hold the Upright to prevent it
from falling until you complete this step.
Remove the indicated parts (24, 31, 32, and 83)
from the Upright (72).
See the CABLE DIAGRAM on page 23 and
identify the Weight Cable (40).
Orient the Weight Cable (40) as shown,
and
insert it through the Upright (72).
Set the Large Pulley (24) that you just removed
over the Weight Cable (40).
Attach the Large Pulley (24) to the Upright (72)
with the M10 x 65mm Socket Bolt (83), the two
M10 Washers (31), and the M10 Locknut (32)
that you just removed.
Before beginning assembly, make sure
that you understand the information in
the box above.
24
72
31 32
31
83
40
ASSEMBLY
• Assembly requires two persons.
• Because of its weight and size, assemble the
strength equipment in the location where it will be
used. Make sure that there is enough clearance
around the strength equipment.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• For help identifying small parts, see page 6.
• The following tools (not included) are required for
assembly:
one adjustable wrench
one Phillips screwdriver
a set of metric hex keys
snap ring pliers
Assembly may be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Large
End
Small
End
Summary of Contents for FLY/REAR DELT F806.0
Page 24: ...24 NOTES...
