7
6.
Tip: Avoid pinching the Wire Harness (43) and
the Pulse Wire (51) during this step.
Attach the
Handlebar (39) to the Upright (2) with four M6 x
30mm Button Screws (37).
6
Avoid pinching the Wires
(43, 51) during this step
5. The Console (4) can be operated with four “D” bat-
teries (not included); alkaline batteries are recom-
mended.
IMPORTANT: If the exercise cycle has
been exposed to cold temperatures, allow it to
warm to room temperature before inserting bat-
teries into the Console. If you do not do this, the
console displays or other electronic compo-
nents may become damaged.
Press the tabs on
the battery covers and remove the battery covers.
Next, insert four batteries into the Console.
Make
sure that the batteries are oriented as shown by
the diagram inside the battery compartment.
Then, reattach the battery covers.
The Console (4) can also be operated with a regu-
lated 6-volt DC 2-amp power supply (not included).
To purchase a power supply, contact the store
where you purchased the exercise cycle or call
the telephone number on the front cover of this
manual. To avoid damaging the console, use
only a manufacturer-supplied power supply.
Plug one end of the power supply into the jack on
the exercise cycle; plug the other end into an outlet
installed in accordance with all local codes and ordi-
nances.
5
4
Batteries
Battery
Covers
Batteries
37
37
39
43
51
2