13
15
14
14. Tip: Avoid pinching the wires. Attach the
Console (5) to the Handlebar (47) with four
M5 x 10mm Truss Screws (81); start all the
Truss Screws, and then tighten them.
81
J
J
K
K
I
L
M
Avoid pinching
the wires
5
5
47
15. Look at the back of the Console (5) and locate
the coupler (I) that has a wire labeled “In” (J) and
a wire labeled “Out” (K).
See the inset drawing. Unplug the wire labeled
"In" (J) and the wire labeled "Out" (K) from the
coupler (I), and discard the coupler.
Then, plug the wire labeled “In” (J) into the
“In” port on the receiver (L), and plug the wire
labeled “Out” (K) into the “Out” port on the
receiver.
Next, peel the backing (M) off the receiver (L),
and press the receiver onto the Handlebar (47)
in the location shown.
Follow the instructions included with the
MYE programmer to program the receiver.
If you purchased the optional MYE receiver to set up a wall of TVs, go to step 15 to install the receiver.
If you did not purchase the optional MYE receiver, go to step 16. To order the optional MYE receiver, see
the back cover of this manual.
47
