8
•
Assembly requires two persons.
•
Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
•
To identify small parts, see page 7.
•
After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
•
Assembly requires the following tools:
the included hex key
one adjustable wrench
one Phillips screwdriver
To avoid damaging parts, do not use power tools.
ASSEMBLY
1.
Make sure that
the power cord
is unplugged. Be
careful not to pinch
the power cord.
Slide the Upright Cover (not shown) off the
Upright (81).
Orient the Upright (81) and the plastic ties as
shown. Set the Upright on the tabs on the Frame
(53). Attach the Upright to the Frame with six
3/8" x 3 1/4" Screws (1), three 3/8" Star Washers
(2), and three 3/8" Flat Washers (43).
Start all
six Screws before tightening them. Be careful
not to pinch any wires.
81
53
1
1
2
Plastic Ties
1
!
!
43
