17
Inspect and tighten all parts of the exercise cycle reg-
ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild soap.
IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
HANDGRIP PULSE SENSOR TROUBLESHOOTING
If the handgrip pulse sensor does not function prop-
erly, see step 5 on page 14.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest setting, the
drive belt may need to be adjusted.
To adjust the drive belt, first unplug the power adapter.
Remove the screws from the left and right shields.
Then, carefully pull the shields away from the frame.
Loosen the M6 x 20mm Hex Screw (101). Tighten the
M10 x 50mm Hex Screw (102) until the Drive Belt (47)
is tight. When the Drive Belt is tight, tighten the M6 x
20mm Hex Screw.
When you are finished, reattach the left and right
shields and then plug in the power adapter.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, first unplug the power
adapter. Remove the screws from the left and right
shields. Then, carefully pull the shields away from the
frame.
Locate the Reed Switch (46). Loosen, but do not
remove, the indicated M4 x 16mm Screw (77). Slide
the Reed Switch slightly toward or away from a
Magnet (30) on the Pulley (29).
Then, retighten the M4 x 16mm Screw (77). Plug in
the power adapter and turn the Left Crank Arm (24)
for a moment. Repeat these actions until the console
displays correct feedback.
When the reed switch is correctly adjusted, reattach
the left and right shields.
MAINTENANCE AND TROUBLESHOOTING
47
46
29
24
101
102
30
77
