9
9. While another person holds the Console (4)
near the Upright (2), connect the console wire
to the Main Wire Harness (43). Next, connect
the console pulse wire to the Upper Pulse Wire
(42).
Insert the excess wires downward into the
Upright (2).
Tip: Start all screws before tightening any of
them. Also, do not pinch the wires during
this step.
Attach the Console (4) to the Upright
(2) with four M4 x 16mm Screws (77).
9
42
Console
Wire
Pulse
Wire
4
77
2
43
Avoid pinching
the wires
10. Identify the Right Pedal (21), which is marked
with a “Right” sticker.
Using an adjustable wrench,
firmly tighten
the
Right Pedal (21)
clockwise
into the Right Crank
Arm (23). Tighten the Left Pedal (not shown)
counterclockwise
into the Left Crank Arm (not
shown).
IMPORTANT: Tighten both pedals as firmly
as possible. After using the exercise cycle
for one week, retighten the pedals.
Adjust the strap on the Right Pedal (21) to the
desired position, and then press the end of the
strap onto the tab on the Right Pedal.
Adjust
the strap on the Left Pedal (not shown) in
the same way.
10
21
Tab
Strap
23
