25
TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and
follow the steps listed. If further assistance is needed, please see the front cover of this manual.
PROBLEM: The power does not turn on
SOLUTION:
a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 11). Use only a single-outlet surge suppres-
sor that meets all of the specifications described on page 11. Important: The treadmill is not com-
patible with GFCI-equipped outlets.
b. After the power cord has been plugged in, make sure that the key is inserted into the console.
c. Check the reset/off circuit breaker located on the
treadmill frame near the power cord. If the switch
protrudes as shown, the circuit breaker has tripped.
To reset the circuit breaker, wait for five minutes
and then press the switch back in.
PROBLEM: The power turns off during use
SOLUTION:
a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait
for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key into the console.
d. If the power still turns off during use, see the front cover of this manual.
PROBLEM: The walking belt slows when walked on
SOLUTION:
a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 11.
b. If the walking belt is overtightened, performance
may decrease and the walking belt may be dam-
aged. If the walking belt is properly tightened,
you should be able to lift each edge of the walk-
ing belt 1 to 2 in. (2.5 to 5 cm) off the walking
platform.
If adjustments need to be made, first
remove the key and unplug the power cord
.
Using the included hex key, turn both 5/16" x 4
3/8" bolts counterclockwise 1/4 of a turn. Then,
plug in the power cord, insert the key, and use
the treadmill for a few minutes. Be careful to
keep the walking belt centered. Repeat until the
walking belt is properly tightened. Note: To
tighten the walking belt, see step c on page 26.
c. If the walking belt still slows when walked on, see the front cover of this manual.
Tripped
Position
Reset
Position
c
5/16" x 4 3/8" Bolts
1 to 2 in.
Summary of Contents for T7.3
Page 38: ...37 NOTES ...