BASIC FAULT FINDING
If your scooter will not start:
(1) Check that the power key switch is turned "on". If it is, the battery condition
indicator meter will be operating. If the green status light on your console is
flashing once per second, charge your batteries.
If the battery condition meter and the green status light fail to operate when the key switch is in
the "on" position, check the following:
(2) Make sure the battery charger is not plugged into the tiller charge socket, this will
prevent the scooter from driving.
(3) Check both battery connectors. Check battery terminal condition.
(4) Check the circuit breaker.
If your scooter stops for no apparent reason, it is probably due to the circuit breaker disconnecting
from the speed control electronic box.
On rare occasions, a temporary overload on the electric circuit can occur – for instance when
climbing a steep incline. If this happens, reset the circuit breaker, wait for two minutes to allow
the temperature activated switch to cool down. Locate the plunger on the circuit breaker through
the access hole. Place a finger onto the circuit breaker and press down on the plunger until it
remains down. You are now ready to drive again. If the circuit breaker trips up again wait for 5
minutes and try again.
1.Fault Diagnosis:
Faults with the main speed controller are rare. Most faults on powered vehicles are associated
with wiring or misconnections due to poor maintenance or incorrect installation of connectors
when assembling the scooter after transportation in a car.
If your scooter should fail to operate, you will be assisted in diagnosis and locating the area of
the fault by observing the number of flashes emitted from the "green" status light on your control
console.
Summary of Contents for 510GDX
Page 44: ...28 ...