Warning:
Caution:
Warning:
Caution:
Warning:
Warning:
Before setting out on your scooter you need to make sure
that your seat is in the correct driving position. Your
distributor will set the seat to the correct height for
your individual needs (note: see warnings on page 9). The
seat has four basic adjustments to assist your comfort.
(Fig 1). This allows the seat to swivel
through 360 NB: It can be re-located on the right side for
your convenience. Pull up fully to release the seat allowing
rotation. Release level to lock the seat into the desired
position.
When driving, the seat should be locked in the
straight ahead position.
The seat base has a series of threaded holes for
universal mounting, on no account must your scooter seat
be relocated from the original factory setting. Failure to
observe this warning will put you into an unstable and
dangerous situation which could cause you harm.
On each side at the rear of
the seat you will find a large black knob (Fig 2). By simply
loosening this knob you are able to slide the armrests in or
out to whatever width you desire. Re-tighten the knobs fully.
You may need a friend to assist you with this initial setting
up operation. This may extend the width of your Scooter.
The backrest of your seat will not fully fold
forwards if armrests are positioned too closely towards one
another.
Do not drive your scooter with the arms removed
or in the raised position.
(Fig 3). The armrest angle
can be adjusted individually to suit your needs. To make
adjustments to the armrest angle you will need two 13mm
spanners (not provided). Lift the arm upwards, you will note
the adjusting bolt. First loosen the locking nut, rotate the
bolt in or out until the required angle is found, lower the
arm and check the angle for comfort; re-adjust as necessary.
Finally tighten the locking nut.
When lowering the arm make certain clothing or
fingers are not positioned under it.
You may need to alter the seat
height setting at a later date, please follow these
instructions.
1.Remove your seat from the Scooter by lifting the seat
Freerider
Seat Lock Lever :
Armrest Width Adjustment:
Seat Height Adjustment:
1.
2.
4.
The seat locking level must lock be lifted up fully
when rotating the seat, failure to observe this may result in
unnecessary wear of the seat post.
3. Armrest Angle Adjustment :
Removing seat from Scooter: The seat mounting post is
designed with a special safety lifting point, this will prevent
the seat from inadvertently dismounting itself in the case
only be demounted by turning the 90 the forward driving
position.
Freerider
Seat Lock Lever :
Armrest Width Adjustment:
Armrest Angle Adjustment :
Seat Height Adjustment:
Warning:
Caution:
Warning:
Caution:
Warning:
Warning:
The seat locking level must lock be lifted up fully
when rotating the seat, failure to observe this may result in
unnecessary wear of the seat post.
OPERATING YOUR FREERIDER SCOOTER
locking lever and lifting the seat clear of the vehicle (see
Fig 4). Note your seat for safety reasons can only be
removed when it is Turned 90 . Please take care when
lifting heavy weights. Place your seat on a soft clean
work area.
FIG 1
FIG 2
FIG 3
FIG 4
8
