VI. BASIC TROUBLESHOOTING
17
Status Fault Codes:
Flash
Description
Meaning
1
Battery Low
The batteries are running low.
Recharge the batteries.
2
Low Battery Fault
The batteries have run out of charge.
Recharge the batteries.
Check the battery and associated connections and
wiring.
Note: The low battery fault flash code,described above, is a requirement of various safety
standards. The scooter will output a visible and audible low battery warning if the battery
voltage drops below 90% of its cut-off voltage.
The warning will be two short flashes, and will take priority over all other flash codes in the
system.
3
High Battery Fault
Battery voltage is too high. This may occur if
overcharged travelling down a long slope.
If travelling down a slope, reduce your speed to
minimise the amount of regenerative charging.
4
Current Limit Time-out
The motor has been exceeding its maximum current
rating for too long.
The scooter may have stalled. Turn the
controller off, leave for a few minutes and turn
back on again.
The motor may be faulty. Check the motor and
associated connections and wiring.
5
Park Brake Fault
Either a park brake release switch is active or
the park brake is faulty.
Check the park brake and associated connections
and wiring.
Ensure any associated switches are in their correct
positions.
6
Throttle OONAPU (Out Of
Neutral At Power Up)
Either a stop function is active or a charger inhibit or
OONAPU condition has occurred.
Release the Stop condition (seat raised etc.)
Disconnect the battery charger
Ensure the throttle is in neutral when turning the
controller on.
The throttle may require re-calibration.
7
Speed Pot Fault
The throttle, speed limit pot, their associated wiring
may be faulty.
Check the throttle and speed pot and associated
connections and wiring.
8
Motor Voltage Fault
The motor or its associated wiring is faulty.
Check the motor and associated connections and
wiring.
9
Other Error
The controller may have an internal fault.
Check all connections and wiring.
Summary of Contents for FR-S13 Series
Page 1: ......
Page 29: ...2018 June V1 ...
