FREERIDER FR-S13 Series, User Instruction Manual

9

IV.  FR-S13 FEATURE GUIDE

5.Headlight switch

Turn on the switch to open the headlight and rear lights.                                                                      

The headlight bulb and LED for rear lights of this FR-S13 series is 12V.

6.Horn

Press the horn button to sound the horn. The horn will sound for as long as the horn 

button is pressed. 

7.Indicator light switch

When you are making a turning manoeuvre on the road, the appropriate switch 

indicator warning light will flash. To cancel the direction indicator, return the switch to 

the centre position. The left direction indicators are activated by "flicking" the switch 

to the left. At the same time, the direction indicator on the power status meter will 

flash too.Please refer to 

Figure 4

.

8.Speed control knob

This allows you to pre-select your desired top speed. The dial is proportional 

to speed and can be set anywhere between minimum ("min") and maximum 

("max") increments. Turn the dial knob anti-clockwise to minimum for a very gentle 

operation, and clockwise towards maximum to increase your speed.

Remember the higher the position the speed dial is set to, the faster the scooter will 

be.

9.Hi/Lo switch

When indoors or in a pedestrian area, the low 4 mph speed range must be engaged, 

choose to use "LOW" gear. The Hi/Lo speed range switch can be operated while the 

scooter is in motion.

Note:This feature is only used in 8 miles/13km/h mode.

10.Handbrake

The lever when pulled towards you, operate two front drum brakes. This manual 

braking system works independently of the main electronic braking system and must 

only be used in an emergency situation. For instance, if the transmission becomes 

disconnected, you will need to brake your scooter.

To operate the manual brake, simply squeeze the lever towards the handlebars, the 

harder you squeeze the more pressure will be applied to the brakes.

Note:This feature is only used in 8 miles/13km/h mode.

11.USB socket

The USB connector on the left hand side of the charge socket allows you to charge 

the small electronic devices(output 5V/1A).                                                                                   

12.Off-Board Charger socket

Your scooter has a lot of power. To ensure it works to its full potential, you must 

maintain both batteries on full charge. Nightly recharging will give the batteries 

longer life and ensure your scooter when you are ready to go. Only use the charger 

supplied with your scooter; other makes of charger may permanently damage your 

batteries and would invalidate the guarantee.

Note: Using USB will reduce scooter's battery capacity.